Chauvet Obsession LED User Manual

Browse online or download User Manual for Floodlights Chauvet Obsession LED. Chauvet Obsession LED User manual

  • Download
  • Add to my manuals
  • Print

Summary of Contents

Page 2 - TABLE OF CONTENTS

5. Appendix 10 12/20/2010 2:38 PM 5. APPENDIX General Troubleshooting SYMPTOM POSSIBLE CAUSE(S) POSSIBLE ACTION(S) Breaker/Fuse keeps blowin

Page 3 - 1. BEFORE YOU BEGIN

5. Appendix 11 12/20/2010 2:38 PM DMX Primer There are 512 channels in a DMX connection. A fixture capable of receiving DMX will require one or

Page 4 - Safety Instructions

5. Appendix 12 12/20/2010 2:38 PM Cable Connectors Cabling must have a male XLR connector on one end and a female XLR connector on the other en

Page 5 - 2. INTRODUCTION

5. Appendix 13 12/20/2010 2:38 PM 3-Pin to 5-Pin Conversion Chart If you use a controller with a 5-pin DMX output connector, you will need to u

Page 6 - 3. SETUP

5. Appendix 14 12/20/2010 2:38 PM General Maintenance To maintain optimum performance and minimize wear, fixtures should be cleaned frequently.

Page 7 - Mounting

TECHNICAL SPECIFICATIONS WEIGHT & DIMENSIONS Length ...

Page 8 - 4. OPERATING INSTRUCTIONS

CONTACT US World Wide General Information CHAUVET® 5200 NW 108th Ave Sunrise, FL 33351 voice: 954.929.1115 fax: 954.929.5560 toll free: 800.

Page 9 - Standalone

CHAUVET®, 2010, All Rights Reserved Information and specifications in this User Manual are subject to change without notice. CHAUVET® assumes no respo

Page 10 - 5. APPENDIX

1. Before You Begin 3 12/20/2010 2:38 PM 1. BEFORE YOU BEGIN What is included  1 x Obsession™ LED  1 x Power Cord  1 x Warranty Card 

Page 11 - Data Cabling

1. Before You Begin 4 12/20/2010 2:38 PM Safety Instructions  Please keep this User Manual for future consultation. If you sell the unit

Page 12 - Setting the Starting Address

2. Introduction 5 12/20/2010 2:38 PM 2. INTRODUCTION Product Overview DMX In DIP Switches Bracket Adjustment Knob Safety Bracket Adju

Page 13 - Setting up a DMX Daisy Chain

3. Setup 6 12/20/2010 2:38 PM 3. SETUP AC Power This fixture runs on 100~240 VAC, 50/60 Hz. Before powering on the unit, make sure the line v

Page 14 - Returns Procedure

3. Setup 7 12/20/2010 2:38 PM Mounting Orientation The Obsession™ LED may be mounted in any position, provided there is adequate room for ven

Page 15 - TECHNICAL SPECIFICATIONS

4. Operating Instructions 8 12/20/2010 2:38 PM 4. OPERATING INSTRUCTIONS Configuring the Starting Address The Obsession™ LED fixture uses thr

Page 16 - CONTACT US

4. Operating Instructions 9 12/20/2010 2:38 PM Standalone Automatic This fixture has preprogrammed operating modes. These are accessed via th

Comments to this Manuals

No comments