CHAUVET, 3000 N 29th Ct, Hollywood, FL 33020 U.S.A (800) 762-1084 – (954) 929-1115 FAX (954) 929-5560 www.chauvetlighting.com 2006-10-11/13:16 Q-M
Operating Instructions Q-Mix User Manual 10 2006-10-11/13:16 Daisy Chain ConnectionController not required for Master/Slave operation DMX Mode Op
Q-Mix User Manual 11 2006-10-11/13:16 Segment Display Configurations The display can be inverted making it easier to read the menu dependi
Q-Mix User Manual 12 2006-10-11/13:16 APPENDIX DMX Primer There are 512 channels in a DMX-512 connection. Channels may be assigned in any manner
Appendix Q-Mix User Manual 13 2006-10-11/13:16 DMX Channel Values DEFAULT VALUE FUNCTION 1 000 Ù 005 006 Ù 039 040 Ù 045 046 Ù 051 052 Ù
Q-Mix User Manual 14 2006-10-11/13:16 Maintenance To maintain optimum performance and minimize wear fixtures should be cleaned frequently. Usag
Appendix Q-Mix User Manual 15 2006-10-11/13:16 General Troubleshooting Applies to Symptom Solution(s) Lights Foggers & Snow Controllers
Appendix Q-Mix User Manual 16 2006-10-11/13:16 Technical Specifications WEIGHT & DIMENSIONS Length...
Q-Mix User Manual 2 2006-10-11/13:16 Table of Content BEFORE YOU BEGIN...
Q-Mix User Manual 3 2006-10-11/13:16 Figure 1 - AC Voltage Switch BEFORE YOU BEGIN What is included ¾ Q-Mix™ with ELC bulb ¾ Power cord with p
Q-Mix User Manual 4 2006-10-11/13:16 INTRODUCTION Features Control Features • 2 channel DMX Intelligent Effect • Variable strobe • 11
Introduction Q-Mix User Manual 5 2006-10-11/13:16 Product Overview Control Board Enter Choose Up Down i j SEGMENT BUTTONS I/O PANEL
Q-Mix User Manual 6 2006-10-11/13:16 Slide switch up or down depending on your line voltage.S1SETUP Lamp You will need to install a lamp
Introduction Q-Mix User Manual 7 2006-10-11/13:16 Mounting Orientation Both fixtures can sit on stage or be mounted on a truss using a cla
Q-Mix User Manual 8 2006-10-11/13:16 OPERATING INSTRUCTIONS Control Panel On the control panel you can set the DMX address, set the fixtu
Q-Mix User Manual 9 2006-10-11/13:16 Note! If the fixture is connected to a controller, please disconnect it. The display will read the p
Comments to this Manuals