Intimidator™ Scan LED 200 User Manual (Rev. 4) Page 11 of 20
Set this product in DMX mode to control it with a DMX controller.
1) Connect this product to a suitable power outlet.
2) Turn this product on.
3) Connect a DMX cable from the DMX output of the DMX controller to the DMX
input socket of this product.
When selecting a starting DMX address, always consider the
channels the selected DMX mode uses. If you choose a starting address that is too
high, you could restrict the access to some of the fixture’s channels.
The Intimidator™ Scan LED 200 uses up to 8 DMX channels in its 8-channel DMX
mode, which defines the highest configurable address to 505.
If you are not familiar with the DMX protocol, d
ownload the DMX Primer from
www.chauvetlighting.com.
To select the starting address, do the following:
1) Press <MODE/ESC> until d*** appears on the LED screen.
2) Using <UP> and <DOWN>, select the starting address (001~512).
3) Press <ENTER>.
4) Press <MODE/ESC> until one of the DMX personalities appears on the LED
screen (8-CH, 5-CH).
5) Using <UP> and <DOWN>, select the desired DMX personality.
6) Press <ENTER>.
Only connect 32 fixtures to a single DMX daisy chain!
Comments to this Manuals