Chauvet Rogue R1 Spot User Manual download pdf (Page 17)

Operation

Rogue™ R1 Spot User Manual Rev. 5 -13-

Address

This programming level sets the DMX starting address.

•

Starting from the Main Level screen, select Address, press <ENTER>.

Set the

DMX Address

In this mode, each product will respond to a unique starting address from the DMX

controller. All products with the same starting address will respond in unison.

This option

sets the products DMX address.

• Change the starting address (001–512), press <ENTER>.

Run Mode

This programming level sets the DMX personality and controls the different test modes.

• Starting from the Main Level screen, select Run Mode, press <ENTER>.

DMX Personality

This option selects which DMX Personality the product uses.

1. Highlight DMX, press <ENTER>.

2. Select the DMX personality 16CH or 19CH, press <ENTER>.

• See the DMX Values section for the highest starting address you can select for

each personality.

• Make sure that the starting addresses on the various products do not overlap

due to the new personality setting.

Auto Test

This option runs every attribute individually through 1 cycle.

• Highlight Auto Test, press <ENTER>.

The Auto Test will end after 1 full cycle. You can stop the test by pressing <MENU>

at any time.

Manual Test

This option allows you to run each attribute individually or as a group.

1. Highlight Manual Test, press <ENTER>.

2. Highlight the desired attribute listed on the control panel screen, press <ENTER>.

• Set the attribute value (000–255), press <ENTER>.

3. Repeat step 2 for the other attributes.

When exiting the Manual Test level, the values of all tested channels will go back

to zero.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 28 29

No comments

Chauvet Rogue R1 Spot User Manual Page 17