Chauvet COLORrail User Manual download pdf (Page 8)

Page 8 of 17 COLORrail™ IRC IP User Manual Rev. 5

Configuration

(Standalone)

Set the product in one of the standalone modes to control it without a DMX controller.

• Connect the product to a suitable power outlet.

Never connect a product that is operating in any standalone mode to a DMX string

connected

to a DMX controller. Products in standalone mode may transmit DMX

signals that could interfere with the DMX signals from the controller.

There is no <ENTER> button. After the COLORrail™ IRC IP is configured the

display will show the last item configured.

Auto Run Mode

To enable the Auto Run mode, follow the instructions below:

1. Press <MENU> with long presses repeatedly until AUR shows on the display.

2. Press <MENU> with a short press. The display shows nXX.

3. Use <UP> or <DOWN> to select the number of runs through the auto run loop.

4. Press <MENU> with a short press. The display shows S.XX.

5. Use <UP> or <DOWN> to select the speed of the auto run loop.

6. Press <MENU> with a short press. The display shows F.XX.

7. Use <UP> or <DOWN> to select the strobe speed of the auto run loop.

Auto Programs

To enable the Auto Program mode, follow the instructions below:

1. Press <MENU> with long presses repeatedly until P.XX shows on the display.

2. Use <UP> or <DOWN> to select an auto programs.

3. Press <MENU>.with a short press. The display will show the sub-menus options for

that Auto Program. See Menu Map

4. Press <MENU> with a short press repeatedly until the display shows the sub-menu

options to be configured.

5. Use <UP> or <DOWN> to select the options within the sub-menu.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 16 17

No comments

Chauvet COLORrail User Manual Page 8