Chauvet DMX MEGA STROBE III User Manual download pdf (Page 7)

Setup

Lamp Installation

When replacing the lamp, please wait 15 minutes after powering down to allow the

unit to cool down! Always disconnect from main power prior to lamp replacement.

Do not touch the envelope (glass area) of the bulb with bare hands. If this happens, clean the lamp

with alcohol and wipe it with a lint free cloth before installation.

CH-750B Lamp

Unscrew and release

lamp wires from the main

PCB.

Unscrew grounding wire

from PCB.

Lamp is removed and replaced through the front of the

fixture. You must first remove the glass cover. Attempt to

remove the lamp after you have released all wire leads

from the PCB. Push back on both spring terminal ends

inside the lamp reflector to release the linear lamp from

the grip of both spring terminals and pull lamp outwards

as you apply the pressure. Repeat procedure to replace

and reconnect wire leads to the appropriate terminals on

the PCB. Make sure wires are tightly screwed onto the

PCB.

Remove the 4 corner

screws to allow the

temporary removal of the

safety glass cover.

ST-750 User Manual 7 2007-03-20/15:10

1 2 3 4 5 6 7 8 9 10

No comments

Chauvet DMX MEGA STROBE III User Manual Page 7