Chauvet Kinta X User Manual download pdf (Page 6)

Kinta™ X User Manual 6 Rev. 4

This drawing provides a

general illustration of the

DMX Input/Output panel of

a lighting fixture.

Universal DMX Controller

Continue the link

The fuse is located

inside this

compartment.

Remove using a flat

head screwdriver.

4. SETUP

Fuse Replacement

With a flat head screwdriver wedge the fuse

holder out of its housing. Remove the damaged

fuse from its holder and replace with exact

same type fuse. Insert the fuse holder back in

its place and reconnect power.

Fixture Linking

You will need a serial data link to run light shows of one or more fixtures using a DMX-512 controller

or to run synchronized shows on two or more fixtures set to a master/slave operating mode. The

combined number of channels required by all the fixtures on a serial data link determines the number

of fixtures the data link can support.

Important: Fixtures on a serial data link must be daisy chained in one single line. To comply with the EIA-485

standard no more than 32 devices should be connected on one data link. Connecting more than 32

fixtures on one serial data link without the use of a DMX optically-isolated splitter may result in

deterioration of the digital DMX signal.

Maximum recommended serial data link distance: 500 meters (1640 ft.)

Maximum recommended number of fixtures on a serial data link: 32 fixtures

Data Cabling

To link fixtures together you must obtain data cables. You can purchase CHAUVET-certified DMX

cables directly from a dealer/distributor or construct your own cable. If you choose to create your own

cable please use data-grade cables that can carry a high quality signal and are less prone to

electromagnetic interference.

Setting up a DMX Serial Data Link

1. Connect the (male) 3 pin connector side of

the DMX cable to the output (female) 3 pin

connector of the controller.

2. Connect the end of the cable coming from

the controller which will have a (female) 3

pin connector to the input connector of the

next fixture consisting of a (male) 3 pin

connector.

3. Then, proceed to connect from the output

as stated above to the input of the following

fixture and so on.

Disconnect the power cord before replacing a fuse and always

replace with the same type fuse.

1 2 3 4 5 6 7 8 9 10 11 12 13

Comments to this Manuals

No comments

Chauvet Kinta X User Manual Page 6

Comments to this Manuals

Related products and manuals for Floodlights Chauvet Kinta X