Chauvet Mini 4 Bar User Manual download pdf (Page 10)

Page 10 of 18 Mini 4 Bar™ 2.0 User Manual (Rev. 03)

Configuration

(Standalone)

Set this product in one of the standalone modes to control it without a DMX controller.

1. Connect this product to a suitable power outlet.

2. Turn this product on.

Never connect a product that is operating in any standalone mode, whether Static,

Automatic, or Sound to a DMX string connected to a DMX controller. This is

because products in standalone mode may transmit DMX signals that could

interfere with the DMX signals from the controller.

Sound Active

Mode

To enable the Sound Active mode, do the following:

1. Press <MENU> repeatedly until SND shows on the display.

2. Press <ENTER>.

3. Turn the music on and adjust the microphone sensitivity knob until the product

starts reacting to the beat of the music.

The product will only respond to the low frequencies of the music (bass and

drums).

Automatic Mode

To enable the Automatic Mode, follow the instructions below:

1. Press <MENU> repeatedly until AUTO shows on the display.

2. Press <ENTER>.

3. Use <UP> or <DOWN> to adjust the duration of each step of the automatic

program from S__1 (fast) to S100 (slow).

4. Press <ENTER>.

Master/Slave

Mode

This mode allows a single Mini 4 Bar™ 2.0 unit (the “master”) to control the actions of

one or more Mini 4 Bar™ 2.0 units (the “slaves”) without the need of a DMX controller.

The master unit will be set to operate in either Automatic or Sound Active mode, while

the slave units will be set to operate in Slave Mode. Once set and connected, the slave

units will operate in unison with the master unit.

Configure the units as indicated below.

Slave units:

1. Press <MENU> repeatedly until 512 shows on the display.

2. Press <ENTER> to accept.

3. Set the DMX address to “001”, as previously explained.

4. Connect the DMX input of the first slave unit to the DMX output of the master

unit.

5. Connect the DMX input of the subsequent slave units to the DMX output of the

previous slave unit.

6. Finish setting and connecting all the slave units.

Master unit:

1. Set the master unit to operate in either Automatic or Sound mode, as

previously indicated.

2. Make the master unit the first unit in the DMX daisy chain.

 Configure all the slave units before connecting the master unit to the DMX

daisy chain.

 Never connect a DMX controller to a DMX string configured for Master/Slave

operation because it may interfere with the signals from the master unit.

 Do not connect more than 31 slave units to the master unit.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17 18

Comments to this Manuals

No comments

Chauvet Mini 4 Bar User Manual Page 10

Comments to this Manuals

Related products and manuals for Floodlights Chauvet Mini 4 Bar