Chauvet Q-Beam 260-LED User Manual download pdf (Page 14)

Operation

-10- Q-Beam 260-LED User Manual Rev. 01d

4. Operation

Control Panel

Description

Button Function

<MENU>

Exits from the current menu or

function

<ENTER>

Enables the currently displayed

menu or sets the currently

selected value in to the current

function

<UP>

Navigates upwards through the

menu list and increases the

numeric value when in a function

<DOWN>

Navigates downwards through

the menu list and decreases the

numeric value when in a function

Control Options

You can set the Q-Beam 260-LED start address in the 001~512 DMX range. This allows

for the control of up to 42 fixtures in the 12-channel Advanced personality.

Programming

Carry out all the programming procedures indicated below from the control panel. Refer

to the Menu Map on page 13 to learn how the menu options relate to each other.

To go to an option, press <MENU> repeatedly until the option shows on the display.

To select an option value, press <UP> or <DOWN> until you see the desired value and

press <ENTER> to accept it.

To exit to the previous menu level, press <MENU>.

DMX Operation

1) Enable DMX operation.

a) Go to MENU > INTRO > RUN.

b) Select DMX512.

2) Select a DMX mode.

a) Go to MENU > INTRO > CHANNELS.

b) Select BASIC or ADVANCED.

3) Select the DMX starting address.

a) Go to MENU > INTRO > ADDRESS.

b) Select a starting address, 001~498 (ADVANCED) or 001~501 (BASIC).

Stand-alone

Operation

1) Go to MENU > INTRO > RUN.

a) Select a stand-alone operation mode (AUTO 1, AUTO 2, SOUND 1, SOUND

2, CUSTOM, or TEST).

Master/Slave

Operation

1) Configure the Master fixture.

a) Select a stand-alone mode, as shown above.

2) Configure the Slave fixtures.

a) Go to MENU > INTRO > RUN.

b) Select SLAVE.

The fixture that operates in any stand-alone mode becomes the master.

• Do not connect a DMX controller to the master or slave fixtures.

• Never connect a fixture operating in stand-alone mode to a DMX universe

Display Mode

1) Go to MENU > INTRO > DISPLAY.

a) Select a display mode (60 CLOSE or BRIGHT).

When in the “60 CLOSE” setting, the display backlight will turn off after 60 s.

When in the “BRIGHT” setting, the display backlight will stay on.

Continues on the next page

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Comments to this Manuals

No comments

Chauvet Q-Beam 260-LED User Manual Page 14

Comments to this Manuals

Related products and manuals for Floodlights Chauvet Q-Beam 260-LED