Chauvet SCAN LED 200 User Manual download pdf (Page 8)

3. Setup 8 12/9/2010 10:32 AM

Mounting

Orientation

The Intimidator™ Scan LED 200

may be mounted in any position provided there is adequate

room for ventilation.

Rigging

Be sure that the structure can support the weight of the fixture. Please see the “Technical

Specifications” section of this manual for a detailed weight listing. Mount the fixture securely. This

may be done with a screw, nut and bolt, or a hanging clamp. The hole in each bracket is 13 mm

in size. When rigging, consider routine maintenance and control panel access. Please see the

following notes on installation.

• If the power link out is intended to be used with multiple fixture, take into account the

length of each power cable, and mount the fixtures close enough to one another to

accommodate for this.

• When aiming the fixtures, you may use the bracket/yoke adjustment knob(s). Loosen

the knob(s), adjust to the desired angle, and then tighten the knob(s) by turning

clockwise. Do not use tools for this step, as it may cause damage.

• Use the secondary portion of the hanging bracket to support the fixture in a sitting

position. Please see the diagram below.

• Safety cables must always be used.

In the diagram above, the secondary portion of the hanging bracket is being used as a

ground support.

Hanging Bracket

Bracket Adjustment

Knob

Bracket Adjustment

Knob

Safety

Sitting position

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 18 19

No comments

Chauvet SCAN LED 200 User Manual Page 8