Page 12 of 16 SlimPANEL™ TRI 12 IP User Manual (Rev. 3)
(Standalone)
Set the product in one of the standalone modes to control without a DMX controller.
1. Connect the product to a suitable power outlet.
2. Turn the product on.
Never connect a product that is operating in any standalone mode (Static,
Automatic, or Sound) to a DMX string connected to a DMX controller. Products in
standalone mode may transmit DMX signals that could interfere with the DMX
signals from the controller.
To enable the Automatic Mode, follow the instructions below:
1. Press <MENU> repeatedly until P-- shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to choose an auto program (P1-P5).
4. Press <ENTER> to adjust the speed of the program.
5. Use <UP> or <DOWN>
to adjust the duration of each step of the automatic program
from S__1 (fast) to S100 (slow).
6. Press <ENTER>.
Static Color Mode
To enable the Static Color Mode, follow the instructions below:
1. Press <MENU> repeatedly until C-- shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to choose a color (C1-C7).
4. Press <ENTER>.
Color Mode
To enable the Custom Static Color Mode, follow the instructions below:
1. Press <MENU> repeatedly until U-- shows on the display.
2. Press <ENTER> to choose between colors (r--, g--, b--).
3. Press <UP> or <DOWN> to choose the intensity of the color (000-100).
4. Repeat the steps to mix additional colors to create the color you need.
5. Press <ENTER>.
You can also manually adjust the strobe rate. To do so, do the following:
1. Press <MENU> repeatedly until U-- shows on the display.
2. Press <ENTER> until S-- shows on the display.
3. Press <UP> or <DOWN> to choose the strobe rate (S 0-S 20).
4. Press <ENTER> once you have chosen your desired strobe rate.
Adjustment
You can manually control the dimmer speed to suit any need. To set up your preferred
dimmer speed, do the following:
1. Press <MENU> repeatedly until DIM shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to choose between the dimming types (OFF-DIM3).
4. Press <ENTER>.
Comments to this Manuals