Chauvet Pro-D6 User Manual download pdf (Page 11)

Menu Functions

LCD Readout Mode Details

DMX Addressing- Allows the user to select the

DMX address for each channel independently.

Manually set output level range utilized while

receiving DMX input.

Manual Dimming- Allows operator to manually dim

the fixtures on channels 1-6 without DMX input.

This displays the current channel output

User Configurations

TO SET THE DMX ADDRESS:

1) Select Addr by pressing menu until the display reads correctly. Press enter to reach the second

step of the addressing menu.

2) The first number indicates the channel being addressed, and will flash. The next three numbers

represent the DMX value being assigned. Use the up and down arrow keys to select the correct

value. Once you are satisfied with your input, press enter to confirm your selection.

3) Pressing the menu button to cycle through and reach the Addr menu again will allow you to

assign an address to the next higher channel in numerical value. You must select enter after

each address is inputted to utilize this feature.

TO SET MAXIMUM OUTPUT VALUE IN DMX MODE:

1) Press the menu button until the display reads dnH. Press enter to progress into the menu.

2) You will see the channel being modified flashing on the left side of the display, for channel 1, it

will flash C1.

3) Use the Up and Down arrow keys to select the maximum output value for the selected channel

when DMX value 255 is received. Set the value from 00-FF, where FF represents 100%.

4) Press enter to save changes.

5) Pressing enter a second time will allow you to adjust the same parameters for the next highest

channel. For example, if we had just set channel 1, pressing enter again would allow us access

to channel 2.

Note: For linear dimming, select C1.CU. Non-dimming can be set with the value

C1.nd, which turns the unit to full off when input received is below 40% (DMX value

of 102), and turns to full on when above 60% (DMX value of 153). Lastly, C1.FL

stands for Fluorescent out, which does not turn on a fixture until input level reaches

50% (DMX value 128).

TO MANUALLY SET DIMMING:

1) Press the menu button until nAnU appears on the display.

2) Press enter to enter the menu, at which point the display will read C1.00

3) Use the up and down arrows to set the value from 00-FF, where FF represents 100%.

4) Press enter to confirm the value.

5) The display will stop flashing at this point. If you would like to set another channel, pressing

enter again will allow access to set the manual value for channel 2. Each channel becomes

available once the channel immediately preceding it is set.

Pro-D6 User Manual 11 2/18/2008 12:58 PM

1 2 ... 6 7 8 9 10 11 12 13 14 15

Comments to this Manuals

No comments

Chauvet Pro-D6 User Manual Page 11

Comments to this Manuals

Related products and manuals for Network switches Chauvet Pro-D6