Chauvet Gobo Shot 50W IRC User Manual Page 5

  • Download
  • Add to my manuals
  • Print
  • Page
    / 64
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 4
EN Gobo Shot™ 50W IRC QRG
5
Wired Remote
To operate the Gobo Shot 50W IRC with the included wired remote, plug
the wired remote into the Wired Remote In port on the back of the projector
,
and use the remote as follows.
To control the gobo’s rotation speed, turn the ROTATION SPEED knob to
the desired speed (slow to fast).
To control the direction of the gobo’s rotation, flip
the DIRECTION switch
to either CW (clockwise) or CCW (counter-clockwise).
To control the power to the Gobo Shot™ 50W IRC, flip the MAINS
SWITCH switch to either OFF or ON.
Details can be found in the User Manual, available at
www.chauvetlighting.com.
The Wired Remote In/Out ports allow one Gobo Shot 50W IRC t
o
remotely control the actions of another Gobo Shot 50W IRC
without the
need of an additional wired remote. Using
a standard RJ45 (network)
cable, connect the projector with the wired remote from its
Wired Remote
Out port to the Wired Remote In port of the other projector.
Gobo Shot™
50W IRC projectors configured in this manner operate in unison.
Infrared Remote
Control (IRC)
The Gobo Shot 50W IRC is fully compatible with the Infrared Remote
Control (IRC) from CHAUVET®. For more information on the IRC or to
download instructions, go to
www.chauvetlighting.com.
The following IRC buttons are used with the Gobo Shot™ 50W IRC:
<BLACKOUT> - turns LED on/off
<STROBE> - strobing (020 Hz)
<SPEED> - gobo rotation
Note: After pressing the <SPEED> button, CU
shows on the display until
you increase or decrease the gobo rotation speed (see below).
<%> - master dimmer
<MANUAL> - stops rotation
<FADE/SNAP> - selects clockwise/counter-clockwise
<+> (plus) - increases effect
- to increase gobo rotation, press the SPEED button first (settings 0255)
- to increase strobing, press the STROBE button first (settings S000S100)
- to increase dimming, press the % button first (settings L000L255)
<-> (minus) - decreases effect
- to decrease gobo rotation, press the SPEED button first (settings 0255)
- to decrease strobing, press the STROBE button first (settings S000S100)
- to decrease dimming, press the % button first (settings L000L255)
<0><9> - preset rotation speeds 0 to 9 (slow to fast)
The buttons on the IRC not listed above are reserved for future use with
the Gobo Shot™ 50W IRC.
Page view 4
1 2 3 4 5 6 7 8 9 10 ... 63 64

Comments to this Manuals

No comments