Snapshot OK on Dimmer Outdoor OK Sound Activated DMX512 Master/Slave 115V/230V Switch Replaceable Fuse User Serviceable Duty Cycle MiN™ Spot
4. OPERATING INSTRUCTIONS Navigating the Control Panel Access control panel functions using the four panel buttons located directly underneath the LCD
Menu Map MiN™ Spot User Manual 11 2008-07-15/12:39
User Configurations TO SET THE PAN TO INVERTING OR NON-INVERTING: 1) Press the Mode button until it shows or
Stand-Alone Mode (Auto Mode): This mode allows a single unit to run to a factory installed program in one of two speeds. 1) To set the fixture in au
DMX Channel Values (13 Channel) CHANNEL VALUE FUNCTION1 000 Ù 255 Pan 2 000 Ù 255 Pan Fine 3 000 Ù 255 Tilt 4 000 Ù 255 Tilt Fine 5 000 Ù 255 V
DMX Channel Values (5 Channel) CHANNEL VALUE FUNCTION 1 000 Ù 255 Pan 2 000 Ù 255 Tilt 3 000 Ù 007 008 Ù 134 135 Ù 239 240 Ù 255 Dimmer/Strobe
Troubleshooting Symptom Solution(s) Applies to Lights Foggers & Snow Controllers Dimmers& Chaser Auto shut off Check fan thermal switch rese
Technical Support Address: Service Dept. 3000 N 29th Ct, Hollywood, FL 33020 (U.S.A.) Support (Email): [email protected] Telephone: (954) 929-
General Maintenance To maintain optimum performance and minimize wear fixtures should be cleaned frequently. Usage and environment are contributing f
MiN™ Spot User Manual 19 2008-07-15/12:39 Technical Specifications WEIGHT & DIMENSIONS Length...
TABLE OF CONTENTS MiN™ Spot ...
1. BEFORE YOU BEGIN What is included ¾ 1 x MiN™ Spot ¾ Power Cord ¾ Warranty Card ¾ User Manual Unpacking Instructions Immediately upon receiving a
Safety Instructions Please read these instructions carefully, it includes important information about the installation, usage and maintenance of thi
2. INTRODUCTION Features CONTROL FEATURES • 5 or 13-channel DMX-512 LED moving yoke • Pan: 540o / tilt: 270o • RGB color mixing • Gobo wheel 9 gob
DMX Channel Summary - 5 Channel Mode CHANNEL FUNCTION 1 Pan 2 Tilt 3 Shutter 4 Color Macro 5 Gobo Product Overview Projector Head Lens Fo
3. SETUP Disconnect the power cord before replacing a fuse and always replace with the same type fuse. Fuse Replacement The fuse is located inside t
CABLE CONNECTORS CABLE CONNECTORS Cabling must have a male XLR connector on one end and a female XLR connector on the other end. Cabling must have a m
Master/Slave Fixture Linking 1. Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector of the first fixture.
Comments to this Manuals