Chauvet Scorpion RGY User Manual download pdf (Page 6)

LG-3355 User Manual 6 4/3/2006/19:36

Rear Panel Control Details

1) On/Off switch: Turn on/off the unit.

2) Power cord: This connection supplies main power to the fixture. Be sure the main power

matches the required power of your fixture.

3) Fuse holder: This housing stores the protective fuse. Always replace with the extra same type

fuse. Replacement with anything other than the specified part may damage your unit.

4) Red LED: Power indicator

5) Blue LED: Sound indicator.

6) Master/Slave Mode: Select the master/slaver mode.

7) Signal input/output: uses a _3.5mm stereo microphone cable to link the unit together for

master/slave link.

Master/Slave Operation

Note: Maximum linking in Master/Slave mode is 8 fixtures.

1) Turn Off all projectors.

2) Connect up to 8 fixtures using a daisy chain method. From the signal output of the first projector

to the signal input of the following projector and then repeat for the following projectors.

3) Set the Master/Slave switch on the first unit in the daisy chain to Master and turn this projector

ON before all other projectors.

Important: Turn Master unit On First otherwise link will not be consistent.

4) On all remaining units set the Master/Slave switch to Slave then turn those projectors on.

Power On/O

Signal Out

Signal In

Infrared Receiver

Sound

Sensitivity

Power Cord Fuse

Master/Slave

1 2 3 4 5 6 7 8 9 10

No comments

Chauvet Scorpion RGY User Manual Page 6