4. Operating Instructions 9 12/10/2010 5:16 PM
4. OPERATING INSTRUCTIONS
Configuring the Starting Address
The DMX-4 LED fixture uses up to four DMX channels. The highest channel that the fixture may
be set to in order to function properly is 509. Any address higher than this will prevent access to
all of the channels.
If this is your first time using DMX, we recommend reading the “DMX Primer” section in the
“Appendix”.
This is the operating mode which will allow for control with an external DMX controller. You must
set the starting address and personality for this mode.
Please see the instructions below.
1. Press <MODE> to switch between “DMX Mode” and “Standalone Mode”. Switch it to
“DMX Mode”.
2. Press <MENU> until the LED display reads ~.
3. Using <UP> and <DOWN>, select one of the three personalities.
4. Press <MENU> until the LED display reads ~.
5. Using <UP> and <DOWN>, select the DMX starting address.
This fixture has built-in auto programs with adjustable settings.
Please see the instructions below.
1. Press <MODE> to switch between “DMX Mode” and “Standalone Mode”. Switch it to
“Standalone Mode”.
2. Press <MENU> until the LED display reads ~.
3. Using <UP> and <DOWN>, select one of the programs.
4. Press <MENU> until the LED display reads ~.
5. Using <UP> and <DOWN>, select the desired run speed.
6. Press <MENU> until the LED display reads ~.
7. Using <UP> and <DOWN>, select the desired dimmer level for the program currently
running.
Switch/Dimmer
Switch:
Dimmer:
Comments to this Manuals