Obey™ 10 User Manual 9 Rev.3
Delete a Step
12) Press the PROGRAM button for 3
seconds.
13) Press the Chase button (1~6) for the
corresponding chase you wish to edit.
14) Locate the step in the program by using
the Step Up and Step Down buttons.
15) Press the Auto/Del button to delete the
current step.
16) All FIXTURES LEDs will flash, indicating a
successful delete of the step from the
memory
17) When you have finished deleting the
steps, press & hold the Program button for
3 seconds to exit the Program mode.
Deselect Blackout if LED is lit.
The currently selected scene will be outputted to
the light fixtures connected to the DMX output.
Delete Chase
1) Press the PROGRAM button for 3
seconds.
2) Press and hold the AUTO/DEL button
while pressing the Chase you want to
delete.
3) All LED’s will flash, indicating that the
Chase was successfully erased.
! This will erase all Steps in the Chase!!!
Adding a Step to a Chase
1) Press and hold the PROGRAM button for
3 seconds to enter programming mode.
2) Press the desired CHASE (1~6) button.
3) Use the Step Up/Step Down buttons to
scroll through the chase and arrive at the
step number for which you would like to
add a step to.
4) Select a FIXTURE button.
5) Adjust the Faders to the desired look on
stage.
6) Press Music/Add button and one step
number will be added after the previously
displayed step number. All FIXTURES
LED indicators will flash to confirm
successful copy.
7) Repeat steps 3~6 until all scenes have
been added to the chase.
8) Press and hold the PROGRAM button for
3 seconds to exit programming mode.
The step will be added after the scene displayed
on the digital readout.
Delete a Chase
1) Press and hold the PROGRAM button for
3 seconds to enter programming mode.
2) Press the CHASE button (1~6) to be
deleted.
3) Press and hold the AUTO/DEL button and
the respective CHASE button then release
to delete the chase. All LED’s will blink 3
times. All FIXTURES LED indicators will
flash to confirm successful copy.
Steps will remain programmed on the controller.
Only the chase is affected.
Comments to this Manuals