Chauvet SlimPAR PRO VW User Manual download pdf (Page 9)

SlimPAR Pro VW User Manual 9 Rev. 3

Lens Assembly Replacement

The SlimPAR™ Pro VW

has an option available to replace the secondary LED optics, or lens

assembly. This will alter the beam and field angles of the fixture. The wide-angle lens assembly is

installed at the factory. The narrow lens (15°) assembly is available as an optional accessory

(SPPVWLENS17).

To replace the lens assembly in the SlimPAR™ Pro VW:

1. Remove the four Allen screws from the front trim ring with a #3 metric Allen wrench.

2. Remove the front cover (with glass still attached to the ring).

3. You now have access to the lens assembly. Use a Philips-head screwdriver to remove

the five screws that hold it in place.

4. Carefully remove the lens assembly. The LEDs and board will now be exposed. Use

caution to prevent damage.

5. Place the new lens assembly in the fixture and reinstall the five Philips screws. Tighten

screws as simultaneously as possible to the same tension. Do not over-tighten the

screws as this could cause damage.

6. Put the front cover in place and reinstall the five Allen screws.

Allen screw

Front cover

Lens assembly

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

No comments

Chauvet SlimPAR PRO VW User Manual Page 9