Chauvet 4Bar User Manual download pdf (Page 6)

Page 6 of 15 Mini 4 Bar™ 2.0 User Manual Rev. 7

3. SETUP

AC Power

This product has an auto-

ranging power supply and it can work with an input voltage

range of 100 to 240 VAC, 50/60 Hz.

To determine the power requirements for this product

(circuit breaker, power outlet, and

wiring), use the current value listed on the label affixed to the product’s back panel, or

refer to the product’s specifications chart. The listed current rating indicates the

product’s average current draw under normal conditions.

Always connect this product to a protected circuit

(circuit breaker or fuse),

making sure that it has

an appropriate electrical ground to avoid the risk of

electrocution or fire.

Never connect this product to

a rheostat (variable resistor) or dimmer circuit, even

if the rheostat or dimmer channel serves only as a 0 to 100% switch.

Fuse

Replacement

Follow the instructions below to change the fuse, if necessary.

Disconnect this product from the power outlet before replacing the fuse.

1. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder and pry

out of its housing.

2. Remove the blown fuse from its holder and replace with a fuse of the exact

same type and rating.

3. Insert the fuse holder back into place, and reconnect power.

Although the safety cap does have room for a spare fuse, this product

ships with

no spare fuse.

Always replace a blown fuse of the same type and rating.

Installed fuse

(held by plastic clip)

Spare fuse holder

(inside safety cap)

Safety cap

1 2 3 4 5 6 7 8 9 10 11 ... 14 15

No comments

Chauvet 4Bar User Manual Page 6