Chauvet LED PAR 38 TRI-C User Manual download pdf (Page 15)

Operation

WELL User Manual Rev. 01e -11-

Wireless

Operation

The WELL can operate in W-DMX mode up to 300 m (900 feet) from the W-DMX

transmitter. The W-DMX receiver in the WELL unit must be paired with the W-DMX

transmitter for wireless operation.

Initial Setup

1) Turn the W-DMX transmitter on.

2) Connect the W-DMX transmitter to a DMX controller.

3) Place the WELL unit within 300 m from the W-DMX transmitter.

4) Disconnect any DMX cable from the WELL unit.

5) Push the antenna release to allow the W-DMX antenna to extend outside the metal

housing.

6) Set the antenna in the upright position.

7) Turn the WELL unit on.

Configuration

1) From the WELL’s control panel, go to RUN > DMX.

2) Select the start address, as with any other DMX compatible product.

3) Go to WDMX > ACTI.

4) Select ON.

Fixture Pairing

Fixture Already Paired

1) If the WELL unit has already been paired with the WDMX transmitter, the red LED on

the On/Off switch will flash slowly.

2) In this case, the WELL unit is ready to work in wireless mode.

Pairing the WELL Unit and a new W-DMX Transmitter

1) From the WELL’s control panel, go to WDMX > REST.

2) Select YES (the red LED on the On/Off switch will illuminate solid).

3) From the W-DMX transmitter, press <RESET> (the SIGNAL indicator will flash).

4) Once the transmitter has found the WELL fixture, the SIGNAL indicator on the W-

DMX transmitter will illuminate solid.

5) The red LED on the On/Off switch will flash slowly indicating the presence of DMX

signal.

WDMX Setup

Control Panel

WDMX Transmitter

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

No comments

Chauvet LED PAR 38 TRI-C User Manual Page 15