Chauvet LEDsplash 2 User Manual

Snapshot Ok on Dimmer Outdoor OK Sound Activated DMX512 Master/Slave Autoswitching Transformer Replaceable Fuse User Serviceable Duty Cycle LEDs

4. OPERATING INSTRUCTIONS Operation Stand-Alone Mode (Sound-Active, Auto Mode): This mode allows a single unit to run to the beat of the music, or

DIPSWITCH OPTIONS FUNCTIONS DIPSWITCHES ( ON ) NOTES & DESCRIPTION Color change program None Music/Auto switch Music: Sound Activated, Rotary k

CHANNEL VALUE FUNCTION CH 2 CH 3 CH 4 CH 5 CH 6 000 Ù 029 RGB Control Mode Red 000 Ù 255 Green 000 Ù 255 Blue 000 Ù 255 Strobe 000 Ù 255 030 Ù 059 06

General Troubleshooting Applies to Symptom Solution(s) Lights Foggers & Snow Dimmers& Chaser Controllers Auto shut off Check fan thermal swit

Technical Support Address: Service Dept. 3000 N 29th Ct, Hollywood, FL 33020 (U.S.A.) Support (Email): [email protected] Telephone: (954) 929-1

General Maintenance To maintain optimum performance and minimize wear fixtures should be cleaned frequently. Usage and environment are contributing f

LEDsplash 2 User Manual 16 2008-01-22/09:14 Technical Specifications WEIGHT & DIMENSIONS Length...

TABLE OF CONTENTS 1. BEFORE YOU BEGIN...

1. BEFORE YOU BEGIN What is included ¾ 1 x LEDSplash™ 2 ¾ Power Cord ¾ Warranty Card ¾ User Manual Unpacking Instructions Immediately upon receivin

Safety Instructions Please read these instructions carefully, which includes important information about the installation, usage and maintenance of t

2. INTRODUCTION Features • 6-channel DMX-512 LED wash light • Blackout/static/dimmer/strobe • Static colors and RGB color mixing with or without DM

Product Overview Mounting Bracket Sound Sensitivity Knob Music/Auto Switch Microphone Dipswitches Power

3. SETUP The fuse is located inside this compartment. Remove using a flat head screwdriver. Fuse Replacement With a flat head screwdriver wedge the f

CABLE CONNECTORS Cabling must have a male XLR connector on one end and a female XLR connector on the other end. 2 1 3 OUTPUTTermination reduces signal

Master/Slave Fixture Linking 1. Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector of the first fixture