Chauvet DMX-800 User Manual download pdf (Page 9)

COLORpalette User Manual 9 2010-01-26/15:01

Often, the setup for Master-Slave

and Standalone operation requires

that the first fixture in the chain be

initialized for this purpose via or

DIP-switches. Secondarily, the

fixtures that follow may also require

a slave setting. Please consult the

“Operating Instructions” section in

this manual for complete instructions

for this type of setup and

configuration.

Hanging Clamp

Note!

Clamp is sold separately.

Master/Slave Fixture Linking

1. Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector

of the first fixture.

2. Connect the end of the cable coming from the first fixture which will have a (female) 3 pin

connector to the input connector of the next fixture consisting of a (male) 3 pin connector. Then,

proceed to connect from the output as stated above to the input of the following fixture and so on.

Mounting

Orientation

This fixture may be mounted in any position provided there is adequate room for ventilation.

Rigging

It is important never to obstruct the fan or vents pathway. Mount the

fixture using, a suitable “C” or “O” type clamp. Adjust the angle of

the fixture by loosening both knobs and tilting the fixture. After finding

the desired position, retighten both knobs.

When selecting installation location, take into consideration lamp

replacement access and routine maintenance.

Safety cables should always be used.

Never mount in places where the fixture will be exposed to rain, high

humidity, extreme temperature changes or restricted ventilation.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17

No comments

Chauvet DMX-800 User Manual Page 9