Chauvet Scorpion Sky User Manual download pdf (Page 17)

Scorpion™ RGB Scan EU User Manual (Rev. 01c) Page 17 of 26

Master/Slave

Mode

This mode allows a single Scorpion™ Scan RGB EU unit (the “master”) to control the

actions of one or more Scorpion™ Scan RGB EU units (the “slaves”) without the need

of a DMX controller. The master unit will be set to operate in either Automatic or

Sound, while the slave units will be set to operate in Slave Mode. Once set and

connected, the slave units will operate in unison with the master unit.

Configure the units as indicated below.

Slave units:

1) Press <MENU> repeatedly until shows blinking on the display.

2) Press <ENTER> (SLA will show solid on the display).

3) Connect the DMX input of the first slave unit to the DMX output of the master unit

4) Connect the DMX input of the subsequent slave units to the DMX output of the

previous slave unit.

5) Finish setting and connecting all the slave units.

Master unit:

1) Set the master unit to operate in either Automatic or Sound mode, as previously

indicated.

2) Make the master unit the first unit in the DMX daisy chain.

• Wait until all the slave units are configured and connected before

connecting the master unit to the DMX daisy chain.

• Never connect a DMX controller to a DMX string configured for Master/Slave

operation because it may interfere with the signals from the master unit.

Do not connect more than 31 slave units to the master unit.

Reverse

Motion

To reverse the direction of the pan and tilt motion, follow the instructions below:

1) Press <MENU> repeatedly until to shows blinking on the display.

2) Use <UP> or <DOWN> to select an motion direction ( ~ ), as shown in

Menu Options (page 14).

3) Press <ENTER> (the selected motion direction will show solid on the display).

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 25 26

No comments

Chauvet Scorpion Sky User Manual Page 17