Setup
January 30, 2012 -7- Q-Spot 260-LED User Manual Rev. 02
You may link the Q-Spot 260-LED to a DMX controller using a standard
connection. If using other DMX compatible fixtures with the Q-Spot 260-LED
possible to control them individually with a single DMX controller.
It is also possible to run several DMX compatible fixtures synchronized without a DMX
controller in a master/slave operating mode.
If you are not familiar with the DMX standard, please refer to the DMX Primer and DMX
Connectivity sections in the Appendix chapter of this manual.
The Q-Spot 260-LED uses the standard DMX data connection for its DMX modes,
Advanced and Basic. Refer to the Operation Instructions chapter to learn how to
configure the Q-Spot 260-LED to work in these modes. The DMX Values
give you detailed information regarding the above-mentioned DMX modes.
Master/Slave
Linking
The Master/Slave mode allows a Q-Spot 260-LED fixture
preconfigured program to control several other Q-Spot 260-LED fixtures
without requiring a DMX controller. In this mode, all the slave fixtures will operate in
unison with the master fixture.
When in Master/Slave mode, the Q-Spot 260-LED
units link to each other using the
standard DMX connection.
If you are not familiar with the Master/Slave connectivity, please refer to the DMX
Primer and DMX Connectivity sections in the Appendix chapter of this manual.
The Operation chapter of this manual provides detailed instructions on how to
configure the Master and Slave units.
Comments to this Manuals