LED PAR 38-18UV User Manual 9 Rev. 2
4. OPERATING INSTRUCTIONS
Configuring the Starting Address
Each fixture requires a starting address from 1~512. A fixture requiring one or more channels for
control begins to read the data on the channel indicated by the starting address. For example, a
fixture that uses seven DMX channels and is addressed to start on DMX channel 100, will read data
from channels: 100, 101, 102, 103, 104, 105 and 106. Choose the starting addresses for each fixture
so that the channels used do not overlap. In addition, you should note the starting address selected
for future reference.
The LED PAR 38-18UVB
fixture uses two DMX channels. If this is your first time using DMX, we
recommend reading the “DMX Primer” section in the “Appendix”.
Control Panel Functions
Access control panel functions using the four buttons located directly underneath the LED display on
the included wired remote.
The Control Panel shows the current state of the unit. It is used to select the operating mode, as well
as the sub-features. For a detailed layout of the control panel functions, please see the “menu map”
section on the following page.
Menu Map
This is the automatic program
512 d001~d512
- -
Select 2-channel DMX mode: intensity, strobe;
this also sets the DMX starting address
(
~
)
sND
- - -
This is the sound-activated program. You may
use the sound sensitivity adjustment knob
located on the rear of the fixture to adjust the
~
(default range is
)
-
This is the speed range for the automatic
program
-
-
Select a custom intensity, from low to high
<MENU>
Used to scroll through the
current operating mode,
as well as back out of the
current menu option
<UP>
Used to select increasing
advancement in the value
<DOWN>
Used to select decreasing
advancement in the value
<ENTER>
Used to select a value and
store it to memory
Comments to this Manuals