Chauvet Intimidator COLOR LED User Manual download pdf (Page 16)

Page 16 of 20 Intimidator™ Spot LED 350 User Manual Rev. 7

Master/Slave

Mode

The Master/Slave mode allows a single Intimidator™ Spot LED 350 unit (the “master”) to

control the actions of one or more Intimidator™ Spot LED 350

units (the “slaves”)

without the need of a DMX controller. The master unit will be set to operate in either

Automatic or Sound-Active mode, while the slave units will be set to operate in Slave

ode. Once set and connected, the slave units will operate in unison with the master

unit.

Configure the units as indicated below.

Slave units:

1. Press <MODE/ESC> repeatedly until SLAv shows on the display.

2. Press <ENTER> to accept.

3. Set the DMX address to 001.

4. Connect the DMX input of the first slave unit to the DMX output of the master unit.

5. Connect the DMX input of the subsequent slave units to the DMX output of the

previous slave unit.

6. Finish setting and connecting all the slave units.

Master unit:

1. Set the master unit to operate in either Automatic or Sound-Active mode.

2. Make the master unit the first unit in the DMX daisy chain.

• Configure

all the slave units before connecting the master unit to the DMX

daisy chain.

•

Never connect a DMX controller to a DMX string configured for Master/Slave

operation because the controller

may interfere with the signals from the

master unit.

• Do not connect more than 31 slave units to the master unit.

Reset Software

To reset the software on the Intimidator™ Spot LED 350, do the following:

1. Press <MODE/ESC> repeatedly until rESt shows on the display.

2. Press <ENTER>.

The product will reset all settings in the software to the default

factory settings.

Password

Channel

The Intimidator™ Spot LED 350 contains a password-

protected mode which allows you

to calibrate and troubleshoot any small issues you may have during normal operation.

In order to access this mode, do the following:

1. Press and hold <MODE/ESC> for at least 10 seconds.

2. Use the <UP> and <DOWN> buttons to enter the password: 2323.

3. Press <ENTER>.

In this mode there are several options for adjustment:

Parameter Programming Steps Description

Pan Adjust P128 Manually adjust the pan angle

Tilt Adjust t128 Manually adjust the tilt angle

Gobo Wheel Adjust G128 Manually adjust the gobo wheel

Color Wheel Adjust C128 Manually adjust the color wheel

Focus Adjust F128 Manually adjust the focus

Prism Adjust L000 Manually adjust the prism

Lamp Brightness Adjust d000 Manually adjust the starting

brightness of the lamp

1 2 ... 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Chauvet Intimidator COLOR LED User Manual Page 16

Comments to this Manuals

Related products and manuals for DJ controllers Chauvet Intimidator COLOR LED