Chauvet Atmos User Manual download pdf (Page 12)

Operation

-8- Atmos™ User Manual Rev. 2

4. OPERATION

Control Panel

Description

Button

Function

Enters the programming mode

Controls the pump to modify the output volume

<TIMER>

Starts the timer controlled operation

Allows momentary fog output for as long as the button is held

down

<UP>

Navigates upward through the menu list or increases the numeric

value when in a function

<DOWN>

Navigates downward through the menu list or decreases the

numeric value when in a function

Control Options

You can set the Atmos™ starting address in the 001–512 DMX range. This enables

control of up to 512 products in the 1-channel personality.

Removable Control

Panel

To operate or control the Atmos™ from a distance, the control panel can be removed

using the 2 thumb screws on each side of the panel; it has a 15 foot

cable that is already

installed and can be extended using a standard 5-pin DMX cable up to 200 feet.

Do not exceed 200 feet when extending the control panel cable.

Programming

Refer to the Menu Map to understand the menu options. The menu map shows the main

level and a variable number of programming levels for each option.

Only use Chauvet water-based High Density Fog Fluid (HDF) and Quick

Dissipating Fog Fluid (QDF).

Preparing for

Operation

To prepare the Atmos™ for operation, perform the following steps.

1. Withdraw the fluid tank from its compartment and remove its cap.

2. Verify that the two plastic hoses attached to the cap are in place and in good

condition.

3. Pour Chauvet (HDF or QDF) fog fluid into the tank and replace the cap.

4. Return the tank back to its compartment in the Atmos™.

5. Make sure the plastic hose entering the Atmos™ from the fluid tank cap is not bent

or kinked.

6. Connect the Atmos™ to power and Warming Up shows on the display during the

heating-up process. After approx. 8 minutes, the display changes to Ready To

Atmos when the machine is ready to output fog.

In any of the operation modes, the display must show Ready To Atmos to output

fog.

Startup

The Atmos™ has an On/Off switch. Make sure that the switch is in the OFF position

before plugging the Atmos™ into power.

To start up the Atmos™, do the following:

1. Prepare for operation, as described in Preparing for Operation

2. Press <VOLUME>.

3. Adjust fog output volume by using <UP> or <DOWN>.

Repeat the startup procedure after transporting the Atmos™ or after refilling with

fluid.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18

Comments to this Manuals

No comments

Chauvet Atmos User Manual Page 12

Comments to this Manuals

Related products and manuals for Floodlights Chauvet Atmos