BEAMbar™ User Manual (Rev. 1) Page 9 of 18
Before mounting the product
, read and follow the safety recommendations indicated in
the Safety Notes.
Orientation
The BEAMbar™ may be mounted in any position
; however, make sure adequate
ventilation is provided around the product.
Rigging
• Before deciding on a location, always make sure there is easy access to the product
for maintenance and programming.
• Make sure that the structure or surface onto which you are mounting the product
can support the product’s weight (see the Technical Specifications
).
• When mounting the product overhead, always use a safety cable.
product securely to a rigging point, such as an elevated platform or a truss.
• When rigging the product onto a truss, you should use a mounting clamp of
appropriate weight capacity. The bracket has 13-mm holes, which are
for this purpose.
• When power linking multiple products, you must
always consider the length of the
power linking cable and mount the products close enough for the cable to reach.
• The bracket adjustment
knobs allow for directional adjustment when aiming the
product to the desired angle. Only loosen or tighten the bracket knobs manually.
Using tools could damage the knobs.
• The double-bracketed yoke also serves as floor supports or allows for surface
mounting. When mounting the product on the floor, make sure that the product
cables are away from people and vehicles.
Mounting Diagram
Double-Bracketed
Yoke
Comments to this Manuals