Chauvet COLORado Ridge IP User Manual download pdf (Page 9)

Setup

COLORado™ Ridge IP User Manual Rev. 07 -5-

3. Setup

AC Power

The COLORado™ Ridge IP has an auto-ranging power supply that works with an input

voltage range of 100~240 VAC, 50/60 Hz.

Make sure that you are connecting this product to the proper voltage, as per the

specifications in this manual or on the product’s sticker.

Always connect this product to a protected circuit with an appropriate electrical

ground to avoid the risk of electrocution or fire.

To determine the power requirements for the COLORado™ Ridge IP, refer to the label

affixed to the side of the product. You can also refer to the Technical Specifications chart in

the Technical Information chapter of this manual.

The listed current rating indicates the maximum current draw during normal operation. For

more information, you may download the document Sizing the Circuit Breakers from the

CHAUVET® website: www.chauvetpro.com.

Never connect this product to a rheostat (variable resistor) or dimmer circuit, even if

the rheostat or dimmer channel serves only as a 0 to 100% switch.

AC Plug

The COLORado™ Ridge IP ships with an IP66 power input cord terminated with a

proprietary IP66 connector and an IP66 to Edison power cord adapter. If the power cord

adapter that came with your product has no plug or you need to change the Edison plug,

use the table below to wire the new plug.

Connection Wire (US) Wire (Europe) IP66 Pin Screw Color

AC Live Black Brown 1 Yellow or Brass

AC Neutral White Blue 2 Silver

AC Ground Green/Yellow Green/Yellow 3 Green

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 24 25

No comments

Chauvet COLORado Ridge IP User Manual Page 9