Chauvet DMF-10 User Manual download pdf (Page 7)

DMF-10 User Manual (Rev. 01e) Page 7 of 18

3. SETUP

AC Power

This product has an auto-ranging power supply and it can work with an input voltage

range of 100~240 VAC, 50/60 Hz.

To determine the power requirements for this product (circuit breaker, power outlet, and

wiring), use the current value listed on the label affixed to the product’s back panel, or

refer to the product’s specifications chart. The listed current rating indicates the

product’s average current draw under normal conditions.

Always connect this product to a protected circuit (circuit breaker or fuse),

making sure that it has an appropriate electrical ground to avoid the risk of

electrocution or fire.

Never connect this product to a rheostat (variable resistor) or dimmer circuit, even

if the rheostat or dimmer channel serves only as a 0 to 100% switch.

Fuse

Replacement

This fixture uses an F 2 A, 250 V fuse. Follow the instructions below to change it in case

it blows.

Disconnect this product from the power outlet before replacing the fuse.

1) Wedge the tip of a flat head screwdriver into the slot of the fuse holder and pry it out

of its housing.

2) Remove the blown fuse from its holder and replace it with a fuse of the exact same

type and rating.

3) Insert the fuse holder back into its place, and reconnect power.

Although the safety cap does have room for a spare fuse, this product ships with

no spare fuse.

Always replace a blown fuse with a good fuse of the same type and rating.

Installed fuse

(held by plastic clip)

Safety cap

1 2 3 4 5 6 7 8 9 10 11 12 ... 17 18

No comments

Chauvet DMF-10 User Manual Page 7