Operation
-16- WELL User Manual Rev. 01e
Continued from previous page
This setting allows the user to reset the WELL fixture to its default values, including
deleting the custom programs.
1) Go to SET.
2) Select REST.
3) When prompted, enter the master access password as shown in Control Panel Lock.
4) Wait for the reset process to finish.
Default Values
Parameter Default Value Parameter Default Value
STAT R/G/B.000 LIFE NORM
RUN DMX RGB.W R/G/B.255
COLO UC
TOUR Notes
These notes intent to clarify the way the TOUR DMX personality works.
• Channel 1 (Dimmer) controls the intensity of the currently projected color.
• When the slider is at the highest position (255) the intensity of the output is at its
maximum.
Blue Color
Selection
• Channels 2 though 7 control the intensity ratio of each of the Red, Green, and Blue
colors on each LED panel.
• When these six sliders are at their highest setting (255), the intensity of each color is at
its maximum if SET > COLO is OFF.
• Channel 8 (Macros) selects the required color macro.
• Channel 8 has priority over channels 2 through 7.
• Channel 1 (Dimmer) controls the intensity of the selected color macro.
• Channel 9 controls the strobe frequency (not the intensity) of channels 2 through 7.
• Channel 9 can strobe channels 2 through 7 when the WELL is not running macros
(channel 8 inactive), thus allowing the individual color faders as well as channel 1
(Dimmer) to control the output intensity.
• Channel 9 can strobe channel 8 when the WELL is running macros (channel 8 active),
allowing channel 8 to select the macro and channel 1 to control the output intensity.
• Channel 10 (Auto/Custom) selects the preset auto programs AT.01~10 or the custom
programs PR.01~10.
• Channel 10 has priority over channels 2 through 9.
• Channel 11 determines the speed at which each auto program (AT.01~10) plays.
• Channel 12 selects the dimmer mode and speed. When DIM is set to OFF, the changes
in the RGB and Dimmer faders are linear. Otherwise, DIM1 is the fastest dimmer curve,
while
is the slowest.
Comments to this Manuals