Setup
LFS-5D User Manual Rev. 1 Page 7 of 14
The LFS-5D has an internal auto-ranging power supply and it can work with an input voltage
range of 100 to 240 VAC, 50/60 Hz.
To determine the product’s power requirements (circuit breaker, power outlet, and wiring), use
the current value listed on the label affixed to the product’s back panel, or refer to
Technical
Specifications in this manual. The listed current rating indicates the product’s average current
draw under normal conditions.
For more information, you may download Sizing Circuit Breakers from the Chauvet website
www.chauvetlighting.com/download/.
• Always connect the product to a protected circuit and m
ake sure the product has an
electrical ground.
Replacement
1. Disconnect the product from power.
2. Use a flathead screwdriver to
unscrew the fuse holder cap from the
housing.
3. Remove the blown fuse.
4. Insert a new fuse of the exact same type and rating.
5. Use a flathead screwdriver to screw the fuse holder cap into the housing.
6. Reconnect the product to power.
Always replace a blown fuse with another of the same type and rating.
A spare fuse is not included; however, the safety cap has room for a spare.
The LFS-5D can be used with any type of dimmer. Using a dimmer controls the intensity of the
light allowing fades up and down.
Comments to this Manuals