Chauvet LFS-5 User Manual download pdf (Page 9)

Operation

LFS-5D User Manual Rev. 1 Page 9 of 14

OPERATION

Gobos

Gobos make patterns in the light and can be customized for special events. The LFS-5D uses

V size gobos, which are gobos that have a 25.4 mm outside measurement, a 19 mm image

size and a 1 mm maximum thickness.

The following gobos are included, but any gobo of the correct size can be used.

Included Gobos

Changing Gobos

To change the gobos in the LFS-5D, do the following:

1. Turn off and disconnect the product from power.

2. Place the product on a flat, level surface.

3. Loosen the gobo access door knob.

4. Remove the gobo access door by pressing the knob towards the body of the light and

gently popping the short edge of the door up.

5. Pull the gobo holder out of the gobo slot.

6. Gently pry the gobo holder open so the gobo falls out.

7. Keep the gobo holder pried open and insert a different gobo making sure that the gobo sits

in the center of the gobo holder.

8. Slide the gobo holder back into the gobo slot.

9. Replace the gobo access door by putting the wider edge in place and then using the knob

to press the narrow edge down until the door clicks into place.

10. Tighten the gobo access door knob.

Gobo

Access

Diagram

Knob

Body Of The Light

Gobo

Part Of Gobo Holder

To Pry When Opening

The Gobo Holder

Gobo Holder

Gobo Slot

Long Edge

Short Edge

1 2 3 4 5 6 7 8 9 10 11 12 13 14

No comments

Chauvet LFS-5 User Manual Page 9