Chauvet Mini 4 Bar User Manual download pdf (Page 7)

5. Appendix 7 5/7/2010 1:21 PM

3. SETUP

AC Power

This fixture runs on 100~240 VAC, 50/60 Hz. Before powering on the unit, make sure the line voltage

to which you are connecting it is within the range of accepted voltages.

Always connect the fixture to a switched circuit. Never connect the fixture to a rheostat

(variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used only as a 0

to 100% switch.

To determine the power requirements for a particular fixture, see the label affixed to the back plate of

the fixture or refer to the fixture’s specifications chart. A fixture’s listed current rating indicates its

average current draw under normal conditions.

Always connect the fixture to a circuit with a suitable electrical ground.

Fuse Replacement

1. With a Philips #2 screwdriver unscrew the fuse holder out of its housing.

2. Remove the damaged fuse from its holder and replace with exact same type fuse.

3. Insert the fuse holder back in its place and reconnect power.

See the “Technical Specifications” section for the fuse size.

Disconnect the power cord before replacing a fuse and always

replace with the same type fuse.

The fuse is

located here

1 2 3 4 5 6 7 8 9 10 11 12 13 14

No comments

Chauvet Mini 4 Bar User Manual Page 7