Setup
-12- Nexus™ Aw 7x7 User Manual Rev. 2
Ethernet
Connections
Ethernet
Connections
Diagram
Kling-Net Mode
Art-Net™ Mode
Ethernet connections link Nexus™ Aw 7x7 panels to routers and each other through their
etherCON® ports. Ethernet connections are for running TCP/IP-protocol-based control
system, such as Kling-Net and Art-Net®. All etherCON® ports can be either input or output,
and panels can be linked to each other, but the start of each chain of panels must be a router
port, and there should be no more than 12 Nexus™ Aw 7x7 panels linked off of one router
port.
Do not connect Nexus™ Aw 7x7 panels to the WAN port of the router.
Kling-Net is a network protocol that uses TCP/IP to send DMX over a network and into the
Neutrik® etherCON® connection ports of the Nexus™ Aw 7x7 panels. Kling-Net works
seamlessly with Kling-Net-supported ArKaos software for configuring and mapping display
devices. For more information, see Kling-Net Configuration
.
Kling-Net requires a gigabit (1000 Mbps) Ethernet card and network router.
Art-Net™ is an Ethernet protocol that uses TCP/IP to send DMX signals over a network and
into the etherCON® connection ports of the Nexus™ Aw 7x7 panels. Art-Net™ requires
configuration through the control panel. For more information, see Setting Ethernet Protocols
and Art-Net™.
For more information about Art-Net™, see the Art-Net™ protocol document available on the
Chauvet web site at www.chauvetprofessional.com
.
Nexus™ Aw 7x7 panels do not work with Art-Net™ controllers sending in Broadcast
mode. For information about the controller’s mode, see the controller’s user manual.
Running TCP/IP based
protocol, such as
More
Nexus™ Aw 57x7 Panels
Comments to this Manuals