Chauvet SlimPAR 38 User Manual Page 1

5200 NW 108th Ave Sunrise, FL 33351 (800) 762-1084 – (954) 929-1115 FAX (954) 929-5560 www.chauvetlighting.com Snapshot Use on Dimmer

4. Operating Instructions 10 7/20/2010 5:31 PM Configuring the Starting Address Each fixture requires a starting address from 1~512. A fixture

4. Operating Instructions 11 7/20/2010 5:31 PM Standalone Operation Automatic This fixture has preprogrammed chases. These are accessed via the c

4. Operating Instructions 12 7/20/2010 5:31 PM DMX Channel Values 7-CH Mode CHANNEL VALUE FUNCTION 1 000  255 Red Dimmer: 0%~100% 2 000  25

5. Appendix 13 7/20/2010 5:31 PM 5. APPENDIX DMX Primer There are 512 channels in a DMX connection. Channels may be assigned in any manner.

5. Appendix 14 7/20/2010 5:31 PM Fixture Linking You will need a serial data link to run light shows of one or more fixtures using a DMX contro

5. Appendix 15 7/20/2010 5:31 PM Cable Connectors Cabling must have a male XLR connector on one end and a female XLR connector on the other end

5. Appendix 16 7/20/2010 5:31 PM 3-Pin to 5-Pin Conversion Chart If you use a controller with a 5-pin DMX output connector, you will need to us

5. Appendix 17 7/20/2010 5:31 PM General Maintenance To maintain optimum performance and minimize wear, fixtures should be cleaned frequently.

TECHNICAL SPECIFICATIONS WEIGHT & DIMENSIONS Length...

TABLE OF CONTENTS 1. BEFORE YOU BEGIN ...

1. Before You Begin 3 7/20/2010 5:31 PM 1. BEFORE YOU BEGIN What is included  1 x SlimPAR™ 38  1 x Power Cord  1 x Warranty Card  1

1. Before You Begin 4 7/20/2010 5:31 PM Safety Instructions  Please keep this User Manual for future consultation. If you sell the unit t

2. Introduction 5 7/20/2010 5:31 PM 2. INTRODUCTION Control Features  3 or 7-channel DMX-512 slim LED par can  Operating modes: 3-channe

3. Setup 6 7/20/2010 5:31 PM 3. SETUP AC Power This fixture runs on 100~240 VAC, 50/60 Hz. Before powering on the unit, make sure the line vo

3. Setup 7 7/20/2010 5:31 PM Mounting Orientation The SlimPAR™ 38 may be mounted in any safe position. Rigging Be sure that the structu

3. Setup 8 7/20/2010 5:31 PM DMX controller (only in DMX operation) Signal Linking In order to use this fixture in a DMX or master/slave operat

4. Operating Instructions 9 7/20/2010 5:31 PM 4. OPERATING INSTRUCTIONS Control Panel Functions Access control panel functions using the fou