COLORstrip™ User Manual 12 2010-01-26/14:45
DMX Control Mode
Operating in a DMX Control mode environment gives the user the greatest flexibility when it comes to
customizing or creating a show. In this mode you will be able to control each individual trait of the
fixture and each fixture independently.
DAISY CHAIN CONNECTION
1. Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector of
the first fixture.
2. Connect the end of the cable coming from the first fixture which will have a (female) 3 pin
connector to the input connector of the next fixture consisting of a (male) 3 pin connector. Then,
proceed to connect from the output, as stated above, to the input of the following fixture and so on.
DMX MODE SETUP
1. Press the Mode button until the dispplay reads [SyS] then press Enter.
2. Press the Up and Down buttons until the display reads [S dAd] then press Enter.
3. Set the DMX address value by using the Up and Down buttons.
4. Press the Mode button; use the Up/Down until the display reads [S Aad]. Press Enter to make
changes permanent.
5. Press the Up/Down buttons to return to the DMX control state, the display will read [S dAd].
6. Repeat this for every fixture you wish to address.
You can use the
Master/Slave link to
control multiple units
as one DMX device.
Read the
instructions on the
following page.
Comments to this Manuals