Chauvet LED-FS1 User Manual download pdf (Page 9)

COLORstrip™ User Manual 9 2010-01-26/14:45

This drawing provides a

general illustration of the

DMX Input/Output panel of

a lighting fixture.

Universal DMX Controller

Continue the link

Hanging Clamp

Note!

Clamp is sold separately.

Often, the setup for Master-Slave

and Standalone operation requires

that the first fixture in the chain be

initialized for this purpose via either

settings in the control panel or DIP-

switches. Secondarily, the fixtures

that follow may also require a slave

setting. Please consult the

“Operating Instructions” section in

this manual for complete instructions

for this type of setup and

configuration.

Setting up a DMX Serial Data Link

1. Connect the (male) 3 pin connector side of

the DMX cable to the output (female) 3 pin

connector of the controller.

2. Connect the end of the cable coming from

the controller which will have a (female) 3

pin connector to the input connector of the

next fixture consisting of a (male) 3 pin

connector.

3. Then, proceed to connect from the output

as stated above to the input of the following

fixture and so on.

CHAUVET Certified DMX Data Cables

Order Code Description

DMX1.5 DMX Cable 1.5m/4.9ft

DMX4.5 DMX Cable 4.5m/14.8ft

DMX10 DMX Cable 10m/32.8ft

Master/Slave Fixture Linking

1. Connect the (male) 3 pin connector side of

the DMX cable to the output (female) 3 pin connector of the first fixture.

2. Connect the end of the cable coming from the first fixture which will have a (female) 3 pin

connector to the input connector of the next fixture consisting of a (male) 3 pin connector. Then,

proceed to connect from the output as stated above to the input of the following fixture and so on.

Mounting

ORIENTATION

This fixture may be mounted in any position provided there is adequate room for ventilation.

RIGGING

It is important never to obstruct the fan or vents pathway. Mount the

fixture using, a suitable “C” or “O” type clamp. Adjust the angle of the

fixture by loosening both knobs and tilting the fixture. After finding the

desired position, retighten both knobs.

When selecting installation location, take into consideration lamp

replacement access and routine maintenance.

Safety cables must always be used.

Never mount in places where the fixture will be exposed to rain, high

humidity, extreme temperature changes or restricted ventilation.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 18 19

Comments to this Manuals

No comments

Chauvet LED-FS1 User Manual Page 9

Comments to this Manuals

Related products and manuals for Network switches Chauvet LED-FS1