Chauvet LED-FS1 User Manual download pdf (Page 6)

Page 6 of 10 COLORstrip™ Footswitch User Manual Rev. 3

3. SETUP

Power

The input power for the Foot Controller

is provided by the COLORstrip™ product being

used. The included 6-

pin DIN cable provides both power and signal between the

controller and the product.

To determine the COLORStrip’s power requirements (circuit breaker, p

ower outlet, and

wiring), use the current value listed on the label affixed to the product’s back panel, or

refer to the product’s specifications chart. The listed current rating indicates the

product’s average current draw under normal conditions.

Always connect the COLORstrip™ to a protected circuit

(circuit breaker or fuse).

Make sure the product has

an appropriate electrical ground to avoid the risk of

electrocution or fire.

Never connect the product to

a rheostat (variable resistor) or dimmer circuit, even

if the rheostat or dimmer channel serves only as a 0 to 100% switch.

Mounting

Before mounting the product

, read and follow the safety recommendations indicated in

the Safety Notes.

Orientation

The Foot Controller is designed for use on a floor or floor-like, horizontal surface.

Mounting overhead or vertically is not recommended.

1 2 3 4 5 6 7 8 9 10

No comments

Chauvet LED-FS1 User Manual Page 6