Chauvet LED-FS1 User Manual download pdf (Page 8)

Page 8 of 10 COLORstrip™ Footswitch User Manual Rev. 3

5. TECHNICAL INFORMATION

Product

Maintenance

To maintain optimum performance and minimize wear, you should clean your products

at least twice a month. However, be aware that usage and environmental conditions

could be contributing factors to increase the cleaning frequency.

To clean the product, follow the instructions below:

• Unplug the product from power.

• Wait until the product is at room temperature.

• Use a vacuum (or dry compressed air) and a soft brush to remove dust collected on

the external surface.

•

The surface of the controller may be wiped off with a mild solution of glass cleaner or

isopropyl alcohol applied to a lint-free cotton cloth.

Always dry surfaces carefully after cleaning them.

General Troubleshooting

Symptom Possible Cause Possible Action

Loss of signal

Loose connection through 6-pin DIN cable

Check cable connection

Pin damage or output damage to

COLORstrip™ product

Send product(s) for repair

Internal problem

Send product for repair

Product does not

power on

No energy through COLORstrip™ output

Check power on the Mains

Change COLORstrip™ to another outlet

Loose or damaged 6-pin DIN cable

Check the 6-pin DIN cable for kinks or

damage

Internal problem

Send product for repair

If you still experience problems after trying the provided

solutions, contact

CHAUVET® Technical Support.

1 2 3 4 5 6 7 8 9 10

No comments

Chauvet LED-FS1 User Manual Page 8