Chauvet Mega Moon User Manual download pdf (Page 3)

Mega Moon™ User Manual 3 9/16/2010 4:11 PM

1. BEFORE YOU BEGIN

What is included

 1 x Mega Moon™

 1 x Power Cord

 1 x Warranty Card

 1 x User Manual

Unpacking Instructions

Immediately upon receiving a fixture, carefully unpack the carton, check the contents to ensure that

all parts are present, and have arrived in good condition. Notify the shipper immediately and retain

the packing material for inspection if any parts appear damaged from shipping or the carton shows

signs of mishandling. Save the carton and all packing materials. In the event that a fixture must be

returned to the factory, it is important that the fixture be returned in the original factory box and

packing.

Symbols

This paragraph contains critical installation, configuration or operation information. Failure to comply

with this information may render the fixture partially or completely inoperative, cause damage to the

fixture or cause harm to the operator/user/technician.

This paragraph contains important installation or configuration information. Failure to comply with this

information may prevent the fixture from functioning correctly.

This paragraph reminds you of useful, although not critical, information.

AC Power

This fixture has an auto-switching power supply that can accommodate a wide range of input voltages

(100V - 240VAC, 50/60Hz). Before powering on the unit, make sure the line voltage to which you are

connecting it is within the range of accepted voltages.

Always connect the fixture to a switched circuit. Never connect the fixture to a

rheostat (variable resistor) or dimmer circuit, even if the rheostat or dimmer

channel is used only as a 0% to 100% switch.

To determine the power requirements for a particular fixture, see the label affixed to the back plate of

the fixture or refer to the fixture’s specifications chart. A fixture’s listed current rating indicates its

average current draw under normal conditions.

Before applying power to a fixture, check that the source voltage matches the fixture’s requirement.

Check the fixture or device carefully to make sure that if a voltage selection switch exists, it is set to

the correct line voltage you will use.

Always connect the fixture to a circuit with a suitable electrical ground.

1 2 3 4 5 6 7 8 ... 13 14

No comments

Chauvet Mega Moon User Manual Page 3