Chauvet MiNSpot User Manual download pdf (Page 11)

4. Operating Instructions 11 6/14/2010 4:13 PM

DMX Operation

This is the operating mode which will allow for control with an external DMX controller. You must set the starting

address for this mode. If this is your first time using DMX, then it is recommended that you refer to the “DMX

Primer” section in the “Appendix” of this manual.

1. Press <MENU> until “DMX Address” appears on the LED screen.

2. Press <ENTER>.

3. Using <UP> and <DOWN>, select the desired DMX address (

d 1

d512

4. Press <ENTER>.

The LED indicated on the LED screen will flash rapidly when the fixture is detecting DMX

signal.

Master/Slave

This is the operating mode which will allow 1 fixture to act as the “master” and control all of the other “slave”

fixtures. You must set both the master and the slave(s) fixtures to the correct mode for this operation.

Master Settings:

1. Connect the fixtures with DMX cables, as shown in the “Fixture Linking” section.

2. Use any one of the standalone modes for the master unit. This includes:

NASL

NAFA

, and

NSTS

Slave Settings:

1. Press <MENU> until

d 1

appears on the LED screen.

2. Using <UP> and <DOWN>, set the DMX address to

d 1

3. Press <MENU> until one of the “Operating Modes” appears on the screen.

4. Using <UP> and <DOWN>, set the mode to

SLAv

on the LED screen.

5. Press <ENTER>.

6. The mode will display as

Son

after 5 seconds of inactivity.

Only 1 fixture may be set to master. All others must be set to slave.

Do not connect a DMX controller to the daisy chain for this operating mode.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 22 23

No comments

Chauvet MiNSpot User Manual Page 11