Chauvet MiNSpot User Manual download pdf (Page 7)

3. Setup 7 6/14/2010 4:13 PM

The fuse is located

inside this

compartment.

Remove using a flat

head screwdriver.

3. SETUP

AC Power

This fixture runs on 115 VAC, 60 Hz or 230 VAC, 50 Hz. Before powering on the unit, make sure the

line voltage to which you are connecting it is within the range of accepted voltages. It may be

necessary to change the switch position before plugging in power.

Always connect the fixture to a switched circuit. Never connect the fixture to a rheostat

(variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used only as a 0

to 100% switch.

To determine the power requirements for a particular fixture, see the label affixed to the back plate of

the fixture or refer to the fixture’s specifications chart. A fixture’s listed current rating indicates its

average current draw under normal conditions.

Always connect the fixture to a circuit with a suitable electrical ground.

Fuse Replacement

1. With a flat head screwdriver wedge the

fuse holder out of its housing.

2. Remove the damaged fuse from its

holder and replace with exact same type

fuse.

3. Insert the fuse holder back in its place

and reconnect power.

Disconnect the power cord before replacing a fuse and always

replace with the same type fuse.

1 2 3 4 5 6 7 8 9 10 11 12 ... 22 23

No comments

Chauvet MiNSpot User Manual Page 7