Chauvet Hurricane User Manual download pdf (Page 6)

Page 6 of 13 Hurricane™ 700 User Manual Rev. 9

3. SETUP

AC Power

The Hurricane™ 700

has a fixed voltage power supply and it can work with an input

voltage of either 120 VAC, 60 Hz or 230 VAC, 50 Hz, depending on the specific model.

To determine the product’s power requirements (

circuit breaker, power outlet, and

wiring), use the current value listed on the label affixed to the product

’s back panel, or

refer to the product’s sp

ecifications chart. The listed current rating indicates the

product’s average current draw under normal conditions.

Always connect the product to a protected circuit

(circuit breaker or fuse). Make

sure the product has an appropriate electrical

ground to avoid the risk of

electrocution or fire.

Never connect the product to

a rheostat (variable resistor) or dimmer circuit, even

if the rheostat or dimmer channel serves only as a 0 to 100% switch.

Fuse

Replacement

Disconnect the product from power before replacing the fuse.

1. Disconnect the product from power.

2. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.

3. Pry the fuse holder out of the housing.

4. Remove the blown fuse from the holder.

5. Replace with a fuse of the exact same type and rating.

6. Insert the fuse holder back in place and reconnect power.

A spare fuse is not included; however, the safety cap has room for a spare.

Always replace a blown fuse with another of the same type and rating.

Installed fuse

(held by plastic clip)

Spare fuse holder

(inside safety cap)

Safety cap

1 2 3 4 5 6 7 8 9 10 11 12 13

No comments

Chauvet Hurricane User Manual Page 6