Page 8 of 17 Intimidator Scan™ LED 300 User Manual Rev. 6
Before mounting the product, read and follow the safety recommendations indicated in
the Safety Notes.
Orientation
The Intimidator™ Scan LED 300 may be mounted in any position; however, make sure
adequate ventilation is provided around the product.
Rigging
• Before deciding on a location for the product, always make sure there is easy
access to the product for maintenance and plenty of ventilation.
• Make sure that the structure or surface onto which you are mounting the product
can support the product’s weight. Please see the Technical Specifications
this manual for weight information.
• When mounting the product overhead, always use a safety cable.
product securely to a rigging point, whether an elevated platform or a truss.
• When rigging the product onto a truss, you should use a mounting clamp of
appropriate weight capacity.
• When power linking multiple products, you must
always consider the length of the
power linking cable and mount the products close enough for the cable to reach.
• The bracket adjustment
knobs allow for directional adjustment when aiming the
product to the desired angle. Only loosen or tighten the bracket knobs manually.
Using tools could damage the knobs.
• The rubber feet also serve as floor supports. When mounting the product
floor, make sure that the product
is secured so that it cannot fall over, and that
cables are away from people and vehicles.
Mounting Diagram
Hanging Bracket
Adjustment
Rubber Foot (4)
Bracket Adjustment
Knob
Comments to this Manuals