Chauvet COLORdash Par User Manual download pdf (Page 14)

Operation

-10- COLORdash™ Par-Tri User Manual Rev. 02b

Continued from previous page

Color Settings

The COLOR setting determines how the COLORdash™ Par-Tri generates the white

color based on various RGB settings.

1) Go to SETTINGS.

2) Select COLOR.

3) Select OFF or UC.

OFF = When RGB are all set to “255”, output is maximum.

UC = RGB are set to match the intensity of older fixtures (Universal Color).

Control Panel Lock

This setting allows the user to activate or disable the control panel lock, which keeps

non-authorized personnel from changing the fixture’s settings.

1) Go to PASSWORD.

2) Select ON or OFF.

When the control panel lock is active, the fixture will prompt the user to enter the

password after 30 seconds of control panel inactivity or after turning on the

fixture.

After being prompted to enter the password:

1) Press <UP>, <DOWN>, <UP>, <DOWN>, and <ENTER>

Program Upload

This option allows the user to copy the custom programs of one COLORdash™ Par-Tri

fixture onto other COLORdash™ Par-Tri fixtures by using the Master/Slave method

1) Configure and connect the fixtures in a Master/Slave arrangement, where the

master unit has the custom programs you want to transfer onto the slave units.

2) At the master unit, go to SETTINGS.

3) Select Upload Customs?

4) When prompted, enter the master access password as shown in Control Panel

Lock.

5) When SEND shows, press <ENTER> to start the upload.

6) Wait for the upload process to finish before disconnecting the fixtures.

 During and after the upload, the master and slave units will visually indicate

the status of the process, as follows:

 Yellow means that the upload is running.

 Red means that the upload failed due to an error.

 Green means that the upload completed successfully.

Reset

This setting allows the user to reset the COLORdash™ Par-Tri fixture to its default

values, including the custom programs.

1) Go to SETTINGS.

2) Select Reset to Factory?

3) When prompted, enter the master access password as shown in Control Panel

Lock.

4) Wait for the reset process to finish.

Fan Speed

1) Go to FANS.

2) Select HIGH, NORMAL, AUTO, or LOW.

Be aware that the fixture’s controller may reset the fan speed from LOW or

NORMAL to HIGH if the fixture’s internal temperature is too high.

End of programming instructions

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Comments to this Manuals

No comments

Chauvet COLORdash Par User Manual Page 14

Comments to this Manuals

Related products and manuals for Floodlights Chauvet COLORdash Par