Chauvet Q-Spot 200 User Manual download pdf (Page 8)

3. SETUP

Lamp

You will need to install a lamp prior to the initial operation of the fixture. A 250W MSD lamp is

included.

Warning! When replacing the lamp, please wait 15 minutes after powering down to allow the

unit to cool down! Always disconnect from main power prior to lamp replacement.

Do not touch the envelope (glass area) of the bulb with bare hands. If this happens, clean the lamp

with alcohol and wipe it with a lint free cloth before installation.

LAMP INSTALLATION

1. Remove screws labeled (S1) and pull out lamp socket

plate.

2. If replacing the lamp, remove old lamp first.

3. Holding the new lamp by its base, align the pins on the

lamp with the small hole in the socket and insert the

lamp squarely until the retaining clips on the lamp s

secure the lamp tightly.

ocket

4. Clean the glass/envelope of the bulb with an alcohol

wipe or equivalent.

5. Holding the lamp socket plate, insert the tip of the lamp

into the fixture with extreme care. Navigate the lamp all

the way until it reaches the reflector and the lamp base

plate touches the bottom plate of the fixture.

6. Align the screw holes and fasten the screws back onto

the lamp socket plate.

7. Turn the fixture on and adjust the lamp alignment

screws (S2) until the brightest most even area of the

beam is in the center of your spot. It may be necessary

for you to use a controller in order to command the

fixture to display a white beam on a flat surface with no

colors.

Maximizing the life of your lamp

To ensure the longest and most efficient use of the lamp always wait

between 10 and 15 minutes before re-applying power after a shutdown.

Failure to do so could result in premature aging of the lamp and failure to the

electronics that drive it.

Never turn off the power to the unit while the lamp is striking. Always wait 15

minutes after powering on the fixture before powering down. Turning off the lamp

during striking may permanently damage the lamp.

Q-Spot 200 User Manual 8 9/5/2007 2:59 PM

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 26 27

No comments

Chauvet Q-Spot 200 User Manual Page 8