Chauvet Q-Spot 575 User Manual download pdf (Page 10)

Master/Sl

Often, the setup for Master-Slave

and Standalone operation requires

that the first fixture in the chain be

initialized for this purpose via either

settings in the control panel or DIP-

switches. Secondarily, the fixtures

that follow may also require a slave

setting. Please consult the

“Operating Instructions” section in

this manual for complete instructions

for this type of setup and

configuration.

Hanging Clamp

Note!

Clamp is sold sepa

atel

ave Fixture Linking

1. Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector

of the first fixture.

2. Connect the end of the cable coming from the first fixture which will have a (female) 3 pin

connector to the input connector of the next fixture consisting of a (male) 3 pin connector. Then,

proceed to connect from the output as stated above to the input of the following fixture and so on.

Mounting

ORIENTATION

This fixture may be mounted in any position provided there is adequate room for ventilation.

RIGGING

It is important never to obstruct the fan or vents pathway. Mount the

fixture using, a suitable “C” or “O” type clamp. Adjust the angle of the

fixture by loosening both knobs and tilting the fixture. After finding the

desired position, retighten both knobs.

• When selecting installation location, take into consideration lamp replacement

access and routine maintenance.

• Safety cables must always be used.

• Never mount in places where the fixture will be exposed to rain, high

humidity, extreme temperature changes or restricted ventilation.

• A minimum of two mounting points must be used for this fixture.

Q-Wash 575 User Manual 10 2007-01-02/12:55

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 18 19

No comments

Chauvet Q-Spot 575 User Manual Page 10