Chauvet Q-Spot 575 User Manual download pdf (Page 7)

3. SETUP

Lamp

You will need to install a lamp prior to the initial operation of the fixture. A 575W HMI lamp is included.

Warning! When replacing the lamp, please wait 15 minutes after powering down to allow the

unit to cool down! Always disconnect from main power prior to lamp replacement.

Do not touch the envelope (glass area) of the bulb with bare hands. If this happens, clean the lamp

with alcohol and wipe it with a lint free cloth before installation.

Lamp Installation

1) Remove the four cover screws as indicated in

2) ws indicated in

3) wards the back of the head as

4) wards the back of

6) p.

Warning: t be facing directly up

7) cloth and

wards the front of the

10) n towards lamp and tighten the two

11)

Figure A

Figure B

Figure C

Figure D

figure A. Note that this is the side of the cover

with the fan showing.

Remove the two thumbscre

figure B.

Lift the fan to

indicated in figure B.

Pull the reflector housing to

the had as indicated in figure C.

Remove the t

wo lamp screws indicated in

figure D.

Remove the lam

Nipple on lamp mus

or directly down with respect to the head.

In ot

her words, the nipple should NOT be

pointing towards the back of the reflector,

or towards the front of the head. Damage

to the reflector can occur if these

instructions are not followed!

Hold the new lamp with a lint-free

insert into lamp socket, making sure that the

nipple on the lamp is pointing up or do

wn, and

not towards the reflector or front.

Tighten lamp screws.

9) Gently push reflector to

head.

wer fa

thumbscrews.

Replace top cover.

Q-Wash 575 User Manual 7 2007-01-02/12:55

1 2 3 4 5 6 7 8 9 10 11 12 ... 18 19

Comments to this Manuals

No comments

Chauvet Q-Spot 575 User Manual Page 7

Comments to this Manuals

Related products and manuals for Stroboscopes & disco lights Chauvet Q-Spot 575