Chauvet Obey 70 User Manual download pdf (Page 12)

3. Setup 12 10/28/2010 4:27 PM

Copying Physical Fader Assignment

This process will copy the physical fader assignment from one fixture into another fixture.

1. Press <PROGRAM> and <TAP SYNC/DISPLAY>. This will enter the physical fader

assignment mode.

2. Press & hold the fixture button that contains the desired physical fader assignment.

3. While still holding the previous fixture button, press & hold the fixture that you want to

copy into.

4. While still holding the two fixture buttons above, press & hold <MIDI/ADD>.

5. While still holding all three buttons down, release the fixture selected in step # 2 above.

6. While still holding down <MIDI/ADD>, release the fixture selected in step # 3 above.

7. Release <MIDI/ADD>.

8. All fixture LEDs will flash.

9. Press <PROGRAM> and <TAP SYNC/DISPLAY> two times to exit physical fader

assignment mode.

This will not copy the fader-reverse setting(s).

Fader Reverse (0~255/255~0)

This function will allow you to reverse the DMX output of the physical fader(s). This may be useful

for inverting the pan/tilt control. It may also be useful if you have 2 channels of control for the

intensity of a fixture (strobe/dimmer) and always want one of them to be on, unless otherwise

stated.

1. Press <PROGRAM> and <TAP SYNC/DISPLAY> two times. This will enter the fader

reverse assignment mode.

2. Select one of the fixtures: <FIXTURE 1~12> (this will be the fixture that you want to

modify the channels for).

3. Move the <SPEED> fader to select the physical slider (control channel).

4. Move the <FADE TIME> fader to activate/deactivate this function .

5. Press <MIDI/ADD> to save the setting.

6. Repeat steps 3~5 until all of the faders have been assigned for the fixture.

7. Press <PROGRAM> and <TAP SYNC/DISPLAY> one time to exit fader reverse

assignment mode.

Resetting the System

Use this function to revert all settings and scenes back to the state they were in when the product

left the factory.

1. Turn off the unit.

2. Press and hold <BANK UP> and <AUTO/DEL>.

3. Turn on power to the unit (while still holding <BANK UP> and <AUTO/DEL>).

4. All LEDs will blink to indicate a successful reset.

This will erase all scenes, chases, and other settings!

This process may take up to 30 seconds to complete.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

No comments

Chauvet Obey 70 User Manual Page 12